WCDMA - Idle Mode Parameter


Idle Mode Parameter:
qQualMin:
Minimum required quality level in the cell measured in the UE.
qRxLevMin:
Parameter that indicates the min. required signal strength in the cell
qualMeasQuantity:
Used for decision as to whether the 3G ranking for cell selection and reselection is based on Ec/No or RSCP. Default is Ec/No.
qHyst1:
Hysteresis values used for serving cell, when ranking is based on CPICH RSCP
qHyst2:
Hysteresis values used for serving cell, when ranking is based on CPICHEc/No
qOffset1sn:
Signal strength offset b/w source and target cell for cell ranking based on CPICH RSCP.
qOffset2sn:
Signal offset between serving cell and neighbor cell, based on CPICHEc/No.
sIntraSearch:
Decision on when intra-freq. measurements should be performed. Following criteria is used:
sIntraSearch ≥ qQualmeas - qQualMin (where qQualmeas is the value measured by UE )
sInterSearch:
Parameter is used to make decision to start inter-freq. measurements.
sInterSearch ≥ qQualmeas - qQualMin (where qQualmeas is the value measured by UE )
sRatSearch:
Decision on when GSM measurement should be performed in relation to qQualMin.
sRatSearch ≥ qQualMeas – qQualMin (where qQualmeas is the value measured by UE )
sHcsRatSearch:
Decision on when GSM measurement should be performed in relation to qRxLevMin.
sHcsRatSearch ≥ qRxLevMeas – qRxLevMin (where qRxLevMeas is the value measured by UE)

Comments

Popular posts from this blog

SCFT - Single Cell Function test

Troubleshooting for GSM KPIs (SD Block & SD Drop)

PS core network