GSM MS power control Parameter

MS power control
Parameter	Description	Range	Ericsson Dafault Value	Remarks
DMPSTATE	Dynamic MS power control state	ACTIVE, INACTIVE	INACTIVE	-
SSDES	Defines the target value for the desired signal strength uplink measured by the BTS during the stationary phase.	47 to 110 dbm	85	Lower desired SS to prevent interference in Urban Area
INIDES	Defines the target value for the desired signal strength uplink measured by the BTS during the initial phase.	47 to 110 dbm	70	-
SSLEN	Length of stationary signal strength filter	3 to 15 SACCH periods	5	The value of SSLEN > INILEN.
INILEN	Length of initial signal strength filter	0, 2 to 5 SACCH periods	2	Faster when value is lower
LCOMPUL	Path loss compensator factor, uplink. When set to zero, no power control towards SSDES is performed.	0 to 100%	70	-
PMARG	Power margin on the new channel at assignment, intra-cell handover and subcell change and on the old channel at assignment failure or handover failure.	0 to 20 dB	8	-
QDESUL	Desired quality uplink	0 to 70 dtqu	20	-
QLEN	Length of the uplink quality filter	1 to 20 SACCH periods	8	-
QCOMPUL	Quality deviation compensation factor, uplink	0 to 60 %	30	-
REGINT	Regulation interval, stationary, uplink	1 to 30 SACCH periods	3	MS power regulation is performed at intervals specified by REGINT. A new power order is issued only if the calculated power level is different from the current MS power level.
DTXFUL	Number of measurements periods before the full set of measurements are used	0 to 40 SACCH periods	5	-