NSN Cell Report

-

CELL DOCTOR REPORTS(KPI - KEY PERFORMANCE INDICATORS)


023 - BCCH MISSING - FOR HOW MUCH SECS SITE WAS DOWN
051 - GPRS PARAMETER REPORTS - SHOWS GPRS PARAMETER FOR EVERY SECTOR - BASIC PARAMETER - ALSO SHOWS AG BLOCK COUNT
         BCF NAME, ID SEGMENT NAME,ID BTS NAME,ID LAC, RAC, CI
060 - NEIGHBOUR DISCREPANCIES - IF NEIGHBOUR DEFINITION IS WRONGLY CREATED - MODIFIED
061 - SHOWS ONE WAY NEIGHBOUR DEFINITION, IF ANY,  SO IF NEIGHBOUR NEEDED THEN CREATE OTHERWISE DELETE
067 - HANDOVER SYNCHRONIZATION - SYNC PARAMETER - Y OR N SHOULD BE Y IN SAME SITE AND WITH OTHER SITE SHOULD BE N
074 - NEIGHBOUR DATA
076 - CO-BSIC-BCCH NEIGHBOUR IF ANY
073 - UNDEFINED NEIGHBOUR ONLY  DATA AVAILABLE IS SIGNAL STRENGTH, BCCH, BSIC
111 - FREQUENCY PLAN REPORT  WHICH FREQ IS THERE FOR EACH TRX AND BASIC PARA LIKE BSC,BTS NAME, BTS ID,LAC,RAC,CI,BCC,NCC, HOPPING PARA
130 - SDCCH CONGESTION REPORT  HOURLY BASIS
132 -SMS FAILURE REPORT
135 - TCH CONGESTION REPROT HOURLY BASIS
150 - HANDOVER FAILURE RATIO, CELL LEVEL
153 - HANDOVER FAILURE ATTEMPT RATIO, AT NEIGHBOUR LEVEL
154 - HANDOVER ATTEMPT CAUSES WHY HANDOVER ATT WAS THERE.
157 - HANDOVER PER CALL RATIO  HO/CALLS
160 - NETWORK LEVEL TCH CALL DROP RATIO
163 - TCH DROP CALL RATE AT CELL LEVEL - IF CALL DROP AT RF, ABIS, AIF, TR , LAPD,BTS, BCSU,USER
166 - SDCCH DROP CALL RATE AT CELL LEVEL - IF DROP RATE AT RF, ABIS, AIF, LAPD, BTS, BCSU
182 - TCH SDCCH CS PEAK TRAFFIC - MAX ERL, BLOCKING - AVE ERL, BLOCKING - TCH & SDCCH BOTH AT CELL
186 - CELL HAVING MAX. PAGING TRAFFIC
190 - UL INTERFERENCE REPORT AT CELL
196 - TRX QUALITY, INTERFERENCE AT TRX LEVEL FOR PARTICULAR CELL NOT MEETING KPI AS MENTIONED
204 - NETWORK BENCHMARK STATISTICS REPORT
208 - LINK BALANCE PER TRX
229 - GPRS KPI REPORT
232 –DISTANCE CALL STUDY REPORT – GIVES FROM HOW MUCH DISTANCE CALLS ARE INITIATED – IN    PERCENTAGE AND SAMPLES VALUE

216 –CELL ANALYSER – VERY HEAVY REPORT NEEDS MORE TIME – RUNS AT SECTOR LEVEL ONLY GIVES ALL PARAMETER AND EVERY STATISTICS
236 – Half Rate TCH Traffic with available time slots and erlang generated.

MML Commands

ZEEI – SECTOR INFO WITH OPERATIONAL STATE AND HW TYPE ET PCM TRX STATE AND NO, OF CALLS RUNNING AT MOMENT

ZERO – TRX LEVEL PARAMETER
ZEQO – BTS LEVEL PARAMETER INCLUDING HOPPING, QUEUE, GPRS ETC.
ZEHO – HANDOVER CONTROL PARAMETERS
ZEUO – POWER CONTROL PARAMETER
ZEAP –NEIGHBOUR WITH BASIC INFO

ZEAO – NEIGHBOUR WITH ALL PARAMETERS

Popular posts from this blog

SCFT - Single Cell Function test

-
Single Cell Function test SCFT is for verifying whether individual BTS works well or not, by making a single cell function test of BTS hardware and software. Essential items to be tested are as follows: 1) BTS Transmitter Output Measurement Test 2) Initial parameter establishment (Pilot PN/System ID/Site ID/Frequency, Neighbor List) 3) Call Origination and Termination Test 4) Softer Handoff Test/Antenna installation check (Direction, Tilt, Transmission Line) 5) Single Cell Coverage Test 6) Noise Floor Test 7) Parameter check.
Read more

Troubleshooting for GSM KPIs (SD Block & SD Drop)

-
KPIs to be monitored: ·             SD Blocking ·             SD Drop SDCCH Channel: ·    SDCCH channel is a dedicated channel which is using for LAC updation, Call Setup, SMS in Ideal mode. It works in UL & DL SD Blocking: ·    SD Blocking means that you are not getting SD resource for the call origination. When MS connects with Network then RACH and AGCH are provided. After AGCH, SDCCH is provided but if SDCCH is not provided at this time due to some problem or due to unavailable of SD by BSC. KPI Formula in Ericsson: ·             SDCCH CONGESTION = (CCONGS / CCALLS) * 100 ·             CCONGS - Congestion counter. ·  ...
Read more

PS core network

-
Image
The PS core network consists of two parts, the traditional General Packet Radio Service (GPRS) core network and the new Evolved Packet System (EPS) core network. The PS core network connects mobile subscribers to Packet Data Networks (PDNs) such as the Internet, corporate networks or operator services networks.  a functional overview of the PS core network. Logical entities and interfaces are shown in black and form a 2G/3G network, while the blue boxes and lines in Figure  show the LTE/EPC related parts. The LTE/EPC network can be regarded as an extension and evolution of existing 2G/3G networks. From a node implementation perspective, there is no strict border between the two networks. The corresponding logical entities of GPRS and EPS networks can be deployed concurrently in Ericsson PS core nodes, such as the SGSN-MME and EPG; these are marked in red. In addition, Ericsson GPRS nodes can be upgraded with EPC functionality by software only. Network evolution i...
Read more