Automatic FLP - Frequency Load Planning

-

Automatic FLP will enable operators to run Frequency Load Planning (FLP) networks, including Synchronized Radio Networks, with minimum effort and maximum performance. The feature performs daily downlink interference matrix measurements and creates synchronization clusters for synchronization status monitoring. FLP parameters are continuously supervised and automatically adjusted to network changes when needed due to for instance lost synchronization, addition of TRX HW, or changes in hopping frequency sets. The parameters that are put under direct BSC control by Automatic FLP activation are, HSN, FNOFFSET, MAIOs, TSC and FSOFFSET.

By using Automatic FLP an operator will get the following benefits:
·         Maximum capacity gain from FLP (best parameter configuration always used. Parameter settings can be kept continuously optimized)
·         Maximizes performance in all types of FLP networks (for example lower drop call rate, better speech quality)
·         Reduced O&M cost for FLP networks (Ease of use). Parameter settings will be optimized made without user intervention.
·         Necessary parameter changes in response to unplanned network changes can be very fast

·         Possibility to monitor synchronization status for each cell. Enables immediate FLP reconfiguration after loss of synchronization.

Comments

Post a Comment

Popular posts from this blog

SCFT - Single Cell Function test

-
Single Cell Function test SCFT is for verifying whether individual BTS works well or not, by making a single cell function test of BTS hardware and software. Essential items to be tested are as follows: 1) BTS Transmitter Output Measurement Test 2) Initial parameter establishment (Pilot PN/System ID/Site ID/Frequency, Neighbor List) 3) Call Origination and Termination Test 4) Softer Handoff Test/Antenna installation check (Direction, Tilt, Transmission Line) 5) Single Cell Coverage Test 6) Noise Floor Test 7) Parameter check.
Read more

Troubleshooting for GSM KPIs (SD Block & SD Drop)

-
KPIs to be monitored: ·             SD Blocking ·             SD Drop SDCCH Channel: ·    SDCCH channel is a dedicated channel which is using for LAC updation, Call Setup, SMS in Ideal mode. It works in UL & DL SD Blocking: ·    SD Blocking means that you are not getting SD resource for the call origination. When MS connects with Network then RACH and AGCH are provided. After AGCH, SDCCH is provided but if SDCCH is not provided at this time due to some problem or due to unavailable of SD by BSC. KPI Formula in Ericsson: ·             SDCCH CONGESTION = (CCONGS / CCALLS) * 100 ·             CCONGS - Congestion counter. ·  ...
Read more

PS core network

-
Image
The PS core network consists of two parts, the traditional General Packet Radio Service (GPRS) core network and the new Evolved Packet System (EPS) core network. The PS core network connects mobile subscribers to Packet Data Networks (PDNs) such as the Internet, corporate networks or operator services networks.  a functional overview of the PS core network. Logical entities and interfaces are shown in black and form a 2G/3G network, while the blue boxes and lines in Figure  show the LTE/EPC related parts. The LTE/EPC network can be regarded as an extension and evolution of existing 2G/3G networks. From a node implementation perspective, there is no strict border between the two networks. The corresponding logical entities of GPRS and EPS networks can be deployed concurrently in Ericsson PS core nodes, such as the SGSN-MME and EPG; these are marked in red. In addition, Ericsson GPRS nodes can be upgraded with EPC functionality by software only. Network evolution i...
Read more